Re: CCL:G:Conv=N command in G94

 On Wed, 21 May 1997, Chia-Ning Yang wrote:
 > Hello,
 > I happen to forget where to put the command Conver=N in
 > g94 input file.  Can somebody answer me this?
 > Thanks.
 > C. Yang
 >
 Wherever the G94 manual tells you to put it.  My apology if you don't have
 a manual, but doesn't Gaussian still supply them with every purchase?  It
 just seems to me that a large portion of the questions asked here could
 better be answered by searching in manuals, or calling or e-mailing the
 appropriate help desk (Gaussian or whomever is your favourite software
 vendor).
 Jaime Martell, Ph.D.                     Phone: (519) 824-4120 Ext. 8520
 Department of Chemistry & Biochemistry   E-mail: jmartell()at()uoguelph.ca
 University of Guelph
 Guelph, Ontario, Canada N1G 2W1