CCL:G: Help on G03 error: "Incomplete coordinate system"
- From: "Vaibhav Jain"
- Subject: CCL:G: Help on G03 error: "Incomplete coordinate
- Date: Mon, 10 May 2010 09:29:29 -0400
Sent to CCL by: "Vaibhav Jain" [vaibhav_pharmacy_+_yahoo.co.in]
I'm getting a recurrent error during geometry optimization (PM3 level)
jobs, using Gaussian G03W. I can't figure out what this error means and
couldn't find any helping information on the manuals or the web. So I'm
hopping someone from this forum could have any helpful hint.
The system I'm studying is composed of tetramer ie. two dimer system stabilized
by interaction with HCl.
The optimization runs apparently
OK for a number of steps, but eventually it stops with the following
Incomplete coordinate system. Try restarting with
Geom=Check Guess=Read Opt=(ReadFC,NewRedundant)
Incomplete coordinate system.
Error termination via Lnk1e in /opt/g03/l103.exe at Mon May 10 14:27:33 2010.
Job cpu time: 0 days 0 hours 17 minutes 34.1 seconds.
File lengths (MBytes): RWF= 64 Int= 0 D2E= 0 Chk= 47 Scr=
Pls help me solve this error...